Wavenet CAT6A Cables

The Cat6A Outdoor Wavenet 6A04CMXBK2 is a 1000-foot reel of unshielded solid bare copper Ethernet cable built for outdoor network installs at 10G speeds up to 750MHz. It uses 23AWG conductors across four twisted pairs with an HDPE dielectric and a UV-rated PVC jacket that stands up to sun exposure without cracking or degrading over time. A cross-shaped separator runs between the pairs to keep crosstalk low and maintain signal integrity across the full run length. This cable carries the CMX outdoor rating, so it is specifically rated for exposed outdoor environments rather than just indoor conduit runs. It is ETL and C(ETL)US certified to TIA-568-C.2 standards and fully RoHS compliant. The black jacket keeps a low profile when strung along building exteriors or poles.

The Cat6A Plenum Wavenet 6A04FPBL2 is a 1000-foot reel of shielded solid bare copper Ethernet cable built for high-performance 10G networks running at frequencies up to 750MHz. It uses 23AWG conductors across four twisted pairs with an aluminum-foil shield wrapped around them, which helps block electromagnetic interference in electrically noisy environments like industrial floors or data centers. A cross-shaped separator sits between the pairs to keep crosstalk under control and maintain clean, stable signal paths over long runs. FEP insulation on each conductor handles heat well, while the flame-retardant PVC jacket carries a plenum CMP and FT6 rating, so you can run it safely through air-handling spaces like drop ceilings and raised floors. It is ETL and C(ETL)US certified to TIA-568-C.2 standards and fully RoHS compliant. The full 1000-foot box weighs 49 pounds and includes a ripcord for easier termination. You can get it in blue or white jacket colors, making cable identification simple across multiple network runs.

The Cat6A Plenum Wavenet 6A04UPXX2 is a 1000-foot solid bare copper Ethernet cable built for 10-Gigabit networks running at up to 750MHz. It uses 23AWG conductors across four unshielded twisted pairs, separated by a cross-shaped divider that keeps crosstalk low and signal quality high. The plenum-rated (CMP/FT6) flame-retardant PVC jacket makes it safe for air-handling spaces like drop ceilings and raised floors, which is where most commercial runs end up anyway. FEP insulation on each conductor handles heat well and maintains strong dielectric performance. It's ETL and C(ETL)US certified to TIA-568-C.2 standards and fully RoHS compliant.

The Wavenet Cat6A Riser cable (6A04URXX2) is a solid bare copper, 23 AWG unshielded twisted pair cable built for 10 Gigabit Ethernet over runs up to 1000 feet. It's rated to 750 MHz and verified to ANSI/TIA-568-C.2, so you're getting a cable that's been independently tested — not just claimed. The flame-retardant PVC jacket carries both CMR and FT4 fire ratings, which means it's code-compliant for vertical riser installations between floors. Inside, HDPE insulation keeps the signal clean, and a cross-web separator holds the four pairs in place to cut down on crosstalk. There's also a ripcord built in, which makes stripping the jacket during termination a lot less frustrating. It's RoHS compliant and C(ETL)US verified, and it comes on a 1000-foot spool — practical for large commercial or enterprise network builds where you're pulling a lot of cable at once.