Wavenet CAT6 Riser Cables

If you're running network drops through vertical shafts or between floors, this Cat6 Riser Wavenet cable is built for that exact job. It handles up to 600MHz bandwidth across four solid bare copper pairs with HDPE insulation, giving you headroom for gigabit and beyond. The aluminum foil shield reduces electromagnetic interference, and the flame-retardant PVC jacket carries a CMR rating with FT4 certification, so it meets code for riser installations. You get a full 1000 feet on a reel, and the 23AWG solid conductors keep signal loss minimal over longer runs. Wavenet built this to TIA-568-C.2 standards with ETL verification, and the cable includes a ripcord and separator to make termination easier. Operating temperature spans from negative twenty up to seventy-five degrees Celsius, so it handles most building environments. Whether you're wiring an office building, school, or apartment complex, this is the cable you pull when you need shielded performance in a riser-rated jacket.

The Wavenet 6E04URSPLSXX4N is a Cat6 riser cable that skips the central spline you find in most options, which makes it a lot easier to pull through conduits and terminate without fighting a rigid cross-member. It carries a CMR rating and FT4 flame classification, so it is fully approved for vertical riser shafts between floors in office buildings and retail spaces where plenum cable is not required. The cable uses 23 AWG solid bare copper conductors with HDPE insulation and a flame-retardant PVC jacket, keeping the outer diameter to about 0.205 inches. It is tested to 550 MHz and independently verified by ETL to ANSI/TIA-568-C.2, which means the performance is confirmed rather than just claimed. A ripcord sits under the jacket for quick stripping, and the 1000-foot Reelex II box keeps things manageable on the job site. It handles Gigabit Ethernet without issue and comes in nine colors, so you can color-code by floor or department if needed.

If you are running permanent Ethernet links between floors and want clean cable management, this Wavenet Cat6 riser cable on a RIB reel is worth considering. It ships as part number 6E04URXX3N in a thousand-foot Reel-in-Box that dispenses neatly without the tangles of traditional coils. The cable is built from 23 AWG solid bare copper on an unshielded twisted pair design rated up to 600MHz, so you get strong signal quality without shield grounding. It is CMR and FT4 listed for vertical shaft work, TIA-568-C.2 verified, and RoHS compliant. Inside the jacket, a separator keeps pair geometry consistent and a ripcord helps you strip back the sheath quickly. The flame-retardant PVC outer layer is tested to hold up after high-temperature aging, and eight jacket colors are available to keep circuits organized. Whether you are pulling drops for IP cameras, wireless access points, or standard Gigabit runs, this spool gives you code-compliant performance in a box that makes the pull easier.

If you are pulling cable between floors in a commercial building or multi-unit residence, this Wavenet Cat6 riser cable gives you the bandwidth and code compliance you need without paying for plenum-grade materials you do not require. It is rated for 600MHz on an unshielded twisted pair design built around 23 AWG solid bare copper conductors, so signal quality stays strong and consistent across the full thousand-foot run. The CMR and FT4 certifications satisfy inspectors in vertical shafts, while the Reelex II packaging on part number 6E04URXX4N feeds smoothly and resists tangles during long pulls. A separator inside the jacket keeps pair geometry consistent, the ripcord makes stripping fast and clean, and the flame-retardant PVC outer shell is tested to retain tensile strength even after high-temperature aging. Whether you are wiring IP cameras, wireless access points, VoIP phones, or standard Gigabit drops, this TIA-568-C.2 verified, RoHS-compliant spool covers the distance without complicating your install.